37 12 012 Carry Out Ride-Height-Calibration
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Replacement of control unit
- Replacement of wiring harness
- Replacement of ride-height sensor
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize Run Flat Indicator . See 36 11 500 INITIALIZING RUN FLAT INDICATOR (RPA) .
Version with Tyre Pressure Control: initialize Tyre Pressure Control. See 36 11 500 INITIALIZING RUN FLAT INDICATOR (RPA) .