36 11 533 Removing And Installing / Replacing RDC Wheel Electronics: Notes
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a tire sealant has been used, replace the wheel electronics.
When a tire has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
When a tire has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
IMPORTANT:
If the wheel electronics have been removed, the complete valve must be replaced.
Necessary preliminary tasks:
- Remove tire
Follow instructions on initializing Run Flat Indicator . See 36 11 500 INITIALIZING RUN FLAT INDICATOR (RPA) .