34 51 560 Removing And Installing/Replacing Pressure Sensor For DSC
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 1 290
Necessary preliminary tasks:
- Switch off ignition
- Protect brake system against unauthorized actuation
After completing work:
- Flush brake system . See 34 00 025 REPLACING FLUID IN ABS/ASC+T BRAKE SYSTEM .
- Check pressure sensor for leaks
Disconnect plug connection (1).
Detach pressure sensor (2) with special tool 34 1 290 .
Installation:
- Check sealing surfaces and thread of pressure sensor and of hydraulic unit for damage.
- Screw in a new pressure sensor immediately after unscrewing the old pressure sensor.
- Tightening torque. See BRAKES - TIGHTENING TORQUES -- ALPINA .