Bleeding front-axle brake circuit

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Connect bleeder hose with collecting tray to bleeder valve on front right brake caliper.

Close bleeder valve.

Run through bleeding routine with BMW Diagnosis and Information System (DIS) with bleeder valve open.

After routine has finished, press brake pedal 5 times down to floor; clear bubble-free brake fluid must flow out.

Close bleed valve.

Repeat procedure at front left.

Fig 1: Connecting Bleeder Hose With Collecting Tray To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off brake fluid changer and remove from expansion tank.

Check brake fluid level.

Close expansion tank.

NOTE: Take care of rubber gasket (1) in lid.

Fig 2: Locating Brake Fluid Level

Courtesy of BMW OF NORTH AMERICA, INC.