33 33 001 Replacing Left Or Right Rear Axle Carrier Tension Strut
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle
Driving without compression struts is not permitted! Risk of damage!
The rear axle carrier must be supported at the front is both tension struts have to be replaced!
Driving without compression struts is not permitted! Risk of damage!
The rear axle carrier must be supported at the front is both tension struts have to be replaced!
Necessary preliminary tasks:
- Remove rear lip
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut. See 37 13 110 REMOVING AND INSTALLING/REPLACING PRESSURE LINE FOR OSCILLATING MOTOR/REAR AXLE .
Release screw (1).
Tightening torque. See REAR AXLE - TIGHTENING TORQUES - ALPINA .
Remove heat shield (2) from clip (3) on fuel tank retaining strap.
Installation:
Check clip (3) for damage and replace if necessary.
Release screws (1).
Tightening torque. See REAR AXLE - TIGHTENING TORQUES - ALPINA .
Release screw (2) and remove tension strut (3).
Secure rear axle carrier by inserting screw (2).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread inserts.
Tightening torque. See REAR AXLE - TIGHTENING TORQUES - ALPINA .