33 17 005 Replacing Rubber Mount For Rear Differential Mounting At Rear

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 281
33 4 282
33 4 283
33 4 284
33 4 465
33 4 466

IMPORTANT: Observe safety instructions for raising the vehicle.

Necessary preliminary tasks:

Remove rear differential . See 33 10 010 REMOVING AND INSTALLING/REPLACING REAR DIFFERENTIAL .

Withdraw rubber mount with special tools 33 4 282 , 33 4 281 , 33 4 466 , 33 4 465 and nut (1).

Fig 1: Removing Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circolight (refer to BMW Parts Service).

Align rubber mount by way of elongated hole (1) to vehicle transversal direction.

Fig 2: Identifying Rubber Mount Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Push new rubber mount (1) into special tool 33 4 283 .

Align rubber mount (1) by way of elongated hole to vehicle transversal direction.

Draw in rubber mount with special tools 33 4 282 , 33 4 283 , 33 4 284 , 33 4 466 , 33 4 465 and nut (2) as far as it will go.

Fig 3: Pushing New Rubber Mount Into Special 33 4 283)

Courtesy of BMW OF NORTH AMERICA, INC.