32 41 250 Removing And Installing / Replacing Fluid Reservoir For Power Steering

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 260

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from fluid reservoir
M54, N52: Remove gaiter with resonator
N62, N62TU: Remove intake filter housing/design cover (left).

Release screw (1).

Tightening torque. See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES - ALPINA .

NOTE: If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.

Remove hose clamps if necessary with special tool 32 1 260 .

Disconnect suction line and radiator return line from fluid reservoir.

Lift out fluid reservoir.

Fig 1: Lifting Out Fluid Reservoir

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING UNIT or 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) .
Check pipe connections for leaks