32 41 061 Replacing Power Steering Vane Pump
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING UNIT or 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) .
- Check pipe connections for leaks
- Version with Dynamic Drive: If necessary, carry out initial operation for Dynamic Drive . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .
Necessary preliminary tasks:
- Check function of vane pump . See 32 41 009 CHECKING FUNCTION OF POWER STEERING VANE PUMP .
- Remove vane pump . See 32 41 061 REPLACING POWER STEERING VANE PUMP .
Release screws (1).
Tightening torque. See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES - ALPINA .
Remove belt pulley (2).
Installation:
Lettering on belt pulley (2) points forwards.