32 00 620 Adjusting Rear Axle

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust camber to setpoint value.

Tighten nut (2).

Tightening torque. See REAR AXLE - TIGHTENING TORQUES - ALPINA .

Fig 1: Adjusting Rear Axle

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust toe to specified value.

Tighten nut (2).

Tightening torque. See REAR AXLE - TIGHTENING TORQUES - ALPINA .

Fig 2: Adjusting Toe

Courtesy of BMW OF NORTH AMERICA, INC.