51 47 491 Removing And Installing/Replacing Rear Underbody Protection

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Underbody protection, petrol/gasoline engines

Release screws (1).

Remove underbody protection (2) towards rear.

Installation:

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Removing Underbody Protection Towards Rear

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Remove heat shield (2).

Fig 2: Identifying Heat Shield And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Underbody protection, diesel engines

Release screws (1 to 3).

Remove underbody protection (4) towards rear.

Installation:

Centre underbody protection (4) and tighten down screws (1 to 3).

Fig 3: Removing Underbody Protection Towards Rear

Courtesy of BMW OF NORTH AMERICA, INC.