26 12 001 Replacing Complete Propeller Shaft Centre Bearing (Constant-Velocity Joint)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 7 500
24 0 090
24 1 050
33 1 307

Remove propeller shaft .

IMPORTANT: Propeller shaft is balanced as a unit.

Mark front propeller shaft relative to rear propeller shaft with paint stick.

Marking by means of engraving which causes surface damage (e.g. center mark) is not permitted.

Fig 1: Locating Center Mark On Propeller Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Pull propeller shaft apart.

Installation:

Thread free from grease.

When pushing shaft together, make sure that markings match up.

Insert bolt (1) with thread-locking liquid.

Tightening torque. See PROPELLER SHAFT - TIGHTENING TORQUES - ALPINA .

Fig 2: Identifying Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Remove shim and dust gaiter.

Fig 3: Locating Shim

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off center bearing with special tool 00 7 500 / 33 1 307 and commercially available puller.

Fig 4: Pulling Off Centre Bearing With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Drive new center bearing firmly home with special tool 24 0 090 or 24 1 050 .

NOTE: Bearing inside diameter 30 mm, use special tool 24 0 090 .
Bearing inside diameter 35 mm, use special tool 24 1 050 .

Fig 5: Driving New Centre Bearing Firmly Home With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.