26 11 090 Removing And Installing/Replacing Centering Mount For Propeller Shaft

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 5 500
11 1 310
11 2 030

Necessary preliminary tasks:

Remove propeller shaft . See 11 PROPELLER SHAFT ASSEMBLY .

Fill centering bore (1) completely with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Driving Special Tool (11 1 310) With Plastic Hammer Into Centering Bore

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Fig 2: Identifying Centering And Special Tools (11 2 030) And (00 5 500)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fig 3: Identifying Observe Protrusion Of Centering

Courtesy of BMW OF NORTH AMERICA, INC.

Observe protrusion A = 4 ⁺² mm of centering (1).