00 11 500 Checking/Topping Up Fluid Level In Automatic Transmission (GA6HP26Z/6HP32Z)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Use only the approved transmission fluid. See 3.0 APPROVED AUTOMATIC TRANSMISSION FLUIDS FOR INITIAL FILLINGS AND CORRECTING FLUID LEVELS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Installation:

Tighten down filler plug using

Fig 1: Identifying Hexagon Wrench 8 A/F, Torque Wrench And Socket 8 A/F

Courtesy of BMW OF NORTH AMERICA, INC.

Topping up transmission fluid after a repair:

Stand vehicle on a level surface and secure against rolling off.

Undo filler plug (1).

Installation:

Replace sealing ring.

Top up transmission fluid until it emerges from filling orifice.

Start engine.

Replenish transmission fluid until it emerges from filling orifice.

Screw in filler plug (1).

Tightening torque. Refer to AUTOMATIC TRANSMISSION - TIGHTENING TORQUES .

Press brake pedal to floor and shift through gears 1 to 6 several times at idle speed. Then shift to "P" position (Park).

Then check fluid level.

Fig 2: Identifying Filler Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Checking fluid level:

Connect BMW Diagnosis and Information System (DIS) or BMW MoDiC to vehicle.
Call up Service functions (drive).
Carry out fluid level check in accordance with instructions.