22 32 001 Replacing Rubber Mount For Transmission Mounting
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove complete exhaust system . See 00 EXHAUST SYSTEM COMPLETE .
- Remove heat shield at rear.
- Remove heat shield at front
- Remove transmission underbody panelling
- Observe safety instructions on raising the vehicle. See 00 ... ... RAISING VEHICLE WITH TROLLEY JACK .
Release crash pin.
Installation:
Tightening torque. See ENGINE AND GEARBOX SUSPENSION - TIGHTENING TORQUES -- ALPINA .
When fitting a new cross-member, the crash pin must also be replaced.
Screw head of crash pin must rest on transmission cross - member.
Unscrew nuts (2).
Release both rubber mount nuts on transmission.
Release screws (1) and remove transmission cross-member.