22 11 100 Replacing Right Engine Support Arm (N62/N62TU)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine in installation position
Remove front wheels . See 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL .
Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
Lower front axle carrier . See 31 11 506 LOWERING/RAISING FRONT AXLE CARRIER .
Remove front underbody protection
Observe safety instructions on raising the vehicle. See 00 ... ... RAISING VEHICLE WITH TROLLEY JACK .

Release both engine mounts from above.

Remove grounding strap from engine support arm.

Remove engine support arm from engine block.

Installation:

Clean contact faces in order to ensure a safe ground connection.