22 11 001 Replacing Right Engine Mount (N62/N62TU)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine in installation position.
Release both engine mounts from above
Remove front underbody protection
Remove front wheels . See 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL .
Lower front axle support . See 31 11 506 LOWERING/RAISING FRONT AXLE CARRIER .
Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
Observe safety instructions on raising the vehicle. See 00 ... ... RAISING VEHICLE WITH TROLLEY JACK .

Release screw connection for engine mount at bottom right.

Remove engine mount towards front.

Fig 1: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lug (1) of engine mount must point to middle of vehicle.

Engine mount designations:

Right engine mount: Even component number
Left engine mount: Odd component number

Fig 2: Identifying Lug Of Engine Mount
Courtesy of BMW OF NORTH AMERICA, INC.