00 00 610 Engine Oil Service (N62/N62TU)

WARNING: This page is about a different car, the 2008 BMW Alpina, 2008 BMW 750i, 2007 BMW Alpina, 2007 BMW 750i, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Recycling:

Catch and dispose of used oil.

Observe country-specific waste-disposal regulations.

NOTE: For purposes of clarity, this work step is shown without the reinforcement plate.

Open oil drain plug (1) in oil sump.

Remove oil drain plug (2) on oil filter cap (3).

Release oil filter cover (3).

Fig 1: Identifying Oil Filter Cover And Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace and lubricate sealing rings (1 and 2).

Replace oil filter element (3) and slide into oil filter cover.

Oil filter element (3) must snap audibly into place.

Fig 2: Identifying Oil Filter Element And Sealing Rings

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring.

Install oil drain plug (1) and tighten down.

Tightening torque. See ENGINE - TIGHTENING TORQUES -- ALPINA .

Insert and tighten down oil filter cover (3).

Tightening torque. See ENGINE - TIGHTENING TORQUES -- ALPINA .

Insert oil drain plug (2) on oil filter cap (3) and tighten down.

Tightening torque: 10 Nm.

Fig 3: Identifying Oil Filter Cover And Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Pour in engine oil.

Start engine and run at idle until oil indicator lamp goes out.

Switch off engine, wait approx. 5 minutes and then check engine oil level.

Top up engine oil if necessary.