17 11 046 Removing And Installing/Replacing Module Carrier (BMW ALPINA B7)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove cooling loop for power steering . See 17 11 370 REMOVING AND INSTALLING/REPLACING COOLING LOOP FOR POWER STEERING .

NOTE: Texts refer to and illustrations show the left side. The procedure is identical for the right side.

Unfasten screws.

Installation:

Tightening torque: 5 Nm.

Fig 1: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: When replacing the module carrier, transfer the bracket (1) to the new component.
Unfasten screws.

Installation:

Tightening torque 8 Nm.

Fig 2: Identifying Bracket

Courtesy of BMW OF NORTH AMERICA, INC.