17 11 031 Replacing Fan Cowl (N62)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Remove fan clutch. . See 11 52 020 REMOVING AND INSTALLING OR REPLACING FAN CLUTCH (N62) .

Unfasten screws.

Remove front wall (1).

Fig 1: Locating Screws

G04768988

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Remove radiator cowling (2).

Unclip auxiliary fan cover and remove.

Fig 2: Identifying Radiator Cowling

G04768989

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) on AUC sensor and disconnect.

Unclip plug connection (2).

If necessary, unclip AUC sensor.

Fig 3: Identifying Plug And Plug Connection

G04774134

Courtesy of BMW OF NORTH AMERICA, INC.

Raise fan cowl (1) approx. 3 cm.

Fig 4: Identifying Fan Cowl

G04774135

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, this work step is shown on the fan cowl after it has been removed.

Fold left retaining tab to fan cowl (1).

Remove fan cowl (1) towards top.

Fig 5: Removing Fan Cowl

G04774136

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (2) at bottom on module carrier.

Fig 6: Identifying Retaining Tab

G04774137

Courtesy of BMW OF NORTH AMERICA, INC.