13 72 001 Replacing Air Cleaner Element (N62)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Open retainers (1).

Unlock and disconnect hose.

Raise upper section (2) of intake filter housing and remove to one side.

Fig 1: Identifying Retainers And Upper Section Of Intake Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Remove air cleaner element (1).

Installation:

Clean upper and lower sections of intake filter housing from inside.

Install new air cleaner element.

Fig 2: Identifying Air Cleaner Element

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check sealing ring (1) in upper section (2) of intake filter housing; replace if necessary.

Fig 3: Identifying Sealing Ring And Upper Section Of Intake Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.