65 83 570 Removing And Installing/Replacing Cd Drive For Car Communication Computer

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

12 7 192

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)! See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and earth/ground.

Necessary preliminary tasks:

Remove front trim holder for Car Communication Computer . See 65 83 560 REMOVING AND INSTALLING/REPLACING FRONT TRIM FOR CAR COMMUNICATION COMPUTER .

Release screws (1), remove CD drive and place to one side.

Installation:

Ensure correct routing of cables.

Fig 1: Identifying CD Drive

G04792774

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and remove cover (2) from CD drive.

Fig 2: Identifying Cover From CD Drive

G04792775

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Installation:

Replace warranty seal with supplied seal.

Warranty will be invalidated if seal is damaged!

Fig 3: Identifying Warranty Seal And Side Cover

G04792776

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation:

Ensure correct routing of cables.

Fig 4: Identifying Plug Connection

G04792777

Courtesy of BMW OF NORTH AMERICA, INC.