65 77 055 Removing And Installing/Replacing Emergency Power Siren With Tilt Sensor

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front left wheel arch trim . See 51 71 039 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH COVER (REAR SECTION) .

Release screws (1) and remove cover (2).

Installation:

Make sure rubber grommet (3) is correctly seated.

Fig 1: Identifying Cover Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove housing (2) and disconnect associated plug connection.

Fig 2: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release nut (1) and remove emergency power siren with tilt sensor (2).

Fig 3: Identifying Emergency Power Siren With Tilt Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Guides (1) of emergency power siren (2) must be correctly seated in area (3) of holder (4)!

Fig 4: Identifying Emergency Power Siren

Courtesy of BMW OF NORTH AMERICA, INC.