65 12 071 Removing And Installing/Replacing Amplifier (Hi-FI System)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

NOTE: Comply with notes and instructions on handling optical waveguides. See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS .

Necessary preliminary tasks:

Disconnect battery negative lead . See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Remove flap in luggage compartment panel on left . See 51 47 172 REMOVING AND INSTALLING/REPLACING FLAP IN LUGGAGE COMPARTMENT TRIM, LEFT OR RIGHT .

Release screw (1).

Disconnect plug connection (2) and slide amplifier (3) in direction of arrow out of mounting.

Fig 1: Sliding Amplifier

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lugs (1) must be correctly slid into guide (2).

Check that amplifier (3) is securely seated.

Fig 2: Identifying Amplifier And Lugs With Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding. See VEHICLE PROGRAMMING AND CODING .