63 14 120 Removing and Installing/Replacing Rear Reflector

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317. See ASSEMBLY WEDGES (SET IN PLASTIC CASE)
00 9 323. See ASSEMBLY WEDGES (SET IN PLASTIC CASE)

Unclip rear reflector (1) with special tool 00 9 323. See ASSEMBLY WEDGES (SET IN PLASTIC CASE) on right side and press inwards with special tool 00 9 317. See ASSEMBLY WEDGES (SET IN PLASTIC CASE) .

Remove rear reflector (1) towards rear from rear bumper trim.

Fig 1: Removing Rear Reflector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on rear reflector must not be damaged.

If necessary, replace faulty retainer (2).

Fig 2: Identifying Faulty Retainer And Catches

Courtesy of BMW OF NORTH AMERICA, INC.