61 62 150 Removing And Installing/Replacing Window Washer Pump For Rear Window Washer System
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove trim panel for cover on frame side member on right. See 51 71 447 REMOVING AND INSTALLING OR REPLACING PANEL FOR COVER ON LEFT OR RIGHT SIDE MEMBER .
- Remove wheel arch trim at front right. See 51 71 039 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH COVER (REAR SECTION) .
- Drain fluid reservoir for windscreen washer system
Release screws
Press off side panel slightly.
NOTE:
Side panel shown removed for purposes of clarity.
Disconnect plug connection (1).
Pull windscreen washer pump (2) in direction of arrow out of fluid reservoir for windscreen washer system.
Disconnect hose plug connection (3) from windscreen washer pump (2).
Installation:
Coat sealing ring (4) of windscreen washer pump (2) with antiseize agent.
Ensure hose is laid without kinks.