61 31 221 Removing And Installing/Replacing Both MULTIFUNCTION Steering Wheel Switches

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect battery negative lead . See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .
Remove airbag unit . See 32 34 020 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT .

NOTE: Illustration shows steering wheel removed.

Release screws (1).

Fig 1: Identifying Steering Wheel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring harness.

Disconnect plug connections (2).

Feed wiring harness (3) out of steering wheel.

Pull multifunction steering wheel switches (1) in direction of arrow out of steering wheel.

Fig 2: Pulling Multifunction Steering Wheel Switches Out Of Steering Wheel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure electrical leads are correctly routed.