54 0... Notes on panorama glass roof (initialization/normalization/learning of characteristic curve)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Initialization comprises: NORMALIZATION and LEARNING CHARACTERISTIC CURVE.

The mechanical end positions are recorded and stored during normalization. The characteristic curve is learnt immediately after normalization. When the characteristic curve is learnt, the mechanical closing forces of the panorama glass roof are recorded and stored for correct operation of the anti-trapping mechanism. Initialisation is started and implemented by pressing and holding switch in "Lift" direction. Initialisation depends on installed roof system and software used.

NOTE: Note: Then carry out initialisation:

if the panorama glass roof has been mechanically moved by means of the emergency actuator
in the event of malfunctions, e.g. no one-touch function, no opening or no comfort function possible
after disengagement of the drive unit
after work is carried out on the mechanism of the panorama glass roof
after the control unit has been replaced
After replacement of circumferential gasket

WARNING: The anti-trapping mechanism is not active during initialisation.

For correct initialisation and function, the following conditions must be met:

Ignition ON
at room temperature (23°C ± 5°C)
No direct solar radiation
only when vehicle is at a standstill
Fully charged vehicle battery
in addition, for US vehicles, let engine run to enable key, if necessary

NOTE: Subsequently described processes relate to a completely closed roof system. However, initialisation can be started from any position.

Initialisation process:

Move switch in "Lift" direction and hold (roof system moves to "Lift" position)
In the event of delayed starting or sudden stopping of the panorama glass roof, continue pressing the switch in the "Lift" direction

NOTE: Hold switch depressed for entire process.

After reaching the fully raised position (A), keep the switch pressed for approx. 30 seconds further (initialisation process starts)
Panorama glass roof moves briefly from lift end position (A) in direction of position (B)
Shading system (floating headlining) closes completely
Shading system (floating headlining) opens completely
Panorama glass roof moves to "Closed" position
Panorama glass roof then moves to "Open" end position and immediately back to "Closed" position
After a brief pause, shading system closes completely

Fig 1: Identifying Panorama Glass Roof In Lift End Position

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: After panorama glass roof and shading system close completely, initialisation is finished. Switch can be released.

NOTE:

If the switch is released in the meantime, the entire procedure must be repeated
On completion of successful initialization, the corresponding messages in the check control and the control display go out
Carry out function check (tip function, anti-trapping protection and, if necessary, comfort function)