52 26 311 Removing and Installing/Replacing Lock For Left Or Right Rear Seat Backrest

Unclip lock trim on backrest edge in direction of arrow (1).

Slide back of lock trim in outward direction and remove in direction of arrow (2).

Fig 1: Uncliping Lock Trim On Backrest Edge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Retaining lugs on trim must not be damaged.

Fig 2: Identifying Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Insert plastic wedge from outside between trim (1) and lock.

Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.

Lever inner side of trim (1) with plastic wedge out of catch.

Remove trim upwards.

Fig 3: Inserting Plastic Wedge From Outside Between Trim And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Removing Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed lock (1) out of rear seat backrest.

Tightening torque 52 26 05AZ. See 52 26 REAR SEATS (THROUGH-LOADING SYSTEM)

Fig 5: Identifying Screws And Feed Lock

Courtesy of BMW OF NORTH AMERICA, INC.