51 16 060 Removing And Installing/Replacing Interior Rearview Mirror (With AUTOBEAM)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Work may only be carried out at a room/object temperature of 18 ... 28°C.
If this cannot be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror foot and rearview mirror (e.g. car left to stand indoors or in the shade for at least 30 minutes).

Version with remote control for central locking:

If necessary, disconnect negative lead from battery. See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .

IMPORTANT: To avoid breaking windscreen:
Snap out (press) rearview mirror only in direction of travel towards windscreen.
Do not under any circumstances twist the mirror foot when removing.
Twisting the mirror off the mirror mount will damage the rear catch.
If the rear catch is damaged, the mirror will be loose when installed and must be replaced.

Press on end caps (1) and at same time pull them apart; this releases clip connection of both caps (1).

Twist mirror (2) and detach end caps (1) from mirror and feed out.

Fig 1: Identifying Mirror And End Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining hooks (1 and 2) of end caps (3) must not be damaged.

Fig 2: Identifying Retaining Hooks Of End Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1 and 2).

Installation:

If necessary, pay attention to cable routing for rain sensor.

Fig 3: Identifying Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not pull off rearview mirror (1) from windscreen against direction of travel and or snap out by turning.
When snapping out, avoid damaging rain sensor (3).

Carefully press mirror (1) forwards out of mirror base (2).

If mirror (1) rests on rain sensor (3), snap mirror (1) out in inward direction.

Fig 4: Identifying Rearview Mirror And Rain Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Twist mirror foot by approx. 45° and fit to mirror mount.
Turn mirror foot until it engages on mirror base.

Fig 5: Twisting Mirror Foot
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Normalization or initialization is not necessary.
Autobeam is automatically aligned under the following conditions:

Driving on a motorway/ordinary road at night for approx. 50 km and
Clearly visible road markings

For further information on Autobeam, refer to SBT AUTOBEAM .

Only replace with version with remote control for central locking:

If necessary, initialize all transmitters (ignition keys), refer to Owner's Handbook.