51 15 330 Removing And Installing Or Replacing Rubbing Strip On Left Or Right Front Door

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317
51 0 300

NOTE: Minimum object temperature of rubbing strip and front door ≥ 18°C.
If this temperature is not achieved, the components must be preheated.

Removing rubbing strip:

Heat rubbing strip (1) with hot air blower and detach with special tool 00 9 317 from front door.

Fig 1: Identifying Heat Rubbing Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Cleaning rear door:

For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.

Clean adhesive area of front door with spirit.

Air drying time at least 1 minute.

Do not grip bonding surface.

Fitting rubbing strip:

Pull liner* off rubbing strip (1).

Place rubbing strip (1) over holes (2) in front door and align.

Fit rubbing strip (1) and press down firmly with special tool 51 0 300 over entire adhesive area.

*Liner is the protective film on adhesive tape.

Fig 2: Identifying Rubbing Strip Over Holes

Courtesy of BMW OF NORTH AMERICA, INC.