51 14 011 Replacing Rear BMW Badge

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 323

IMPORTANT: The Instructions on component cementing with double - sided adhesive tape serve as the basis for this repair instruction and must be observed without fail. See 51 14 ... INSTRUCTIONS FOR ATTACHING NUMBER/LETTER DESIGNATION COMBINATION
The BMW badge must be replaced after it is removed.

Removing badge:

Heat BMW badge (1) with hot air blower and carefully lever out with special tool 00 9 323.

Fig 1: Identifying Special Tool (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Installation:

Grommets (1) must not be damaged.

Fig 2: Identifying Grommets And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Pull liner* off adhesive tape (2), position badge over guide pins (3) and press down firmly.

* Liner is the protective film on a new badge.