41 5.... Removing And Installing Door

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Fig 1: Identifying Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Open door up to stop.

Fig 2: Identifying Screw On Door Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts between both hinge elements at top and bottom.

Fig 3: Identifying Nuts Between Both Hinge Elements

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Unhinge door by moving upwards and placing it on a suitable surface.

Installation:

If necessary, adjust door . See 41 5.... ADJUSTING DOOR .

Fig 4: Identifying Plug Connection Of Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.