41 11 028 Replacing Left Engine Carrier (Partial Replacement Before Front Axle)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, General . See 41 0 CONTENTS OF BODY, GENERAL .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved spot-welding apparatus for repairs.

Place vehicle on straightening bench.

Necessary preliminary tasks:

Replace left support carrier.

Following new body parts are required:

(1) Engine carrier, front

Fig 1: Identifying Engine Carrier, Front
Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with measurement a and cut.

Measurement a=150 mm from bore dia. 20 mm

Preparation of new part:

Mark severance cut in accordance with vehicle and cut.

Installation:

Adjust new part to fit with straightening attachment or universal mount.

Weld in reinforcement plate at severance cut. See 41 00... WELDING IN REINFORCEMENT PLATE (STEEL PLATE) .

Internal reinforcement plate in engine carrier is no longer welded. To avoid grinding noises, maintain a gap of approx. 3 mm.

Fig 2: Identifying Measurement A

Courtesy of BMW OF NORTH AMERICA, INC.