37 12 012 Carrying Out Ride-Height-Calibration
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Removal/replacement of ride-height sensor or its control rod
- Replacement of wiring harness
- Replacement of air supply unit control unit
- Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize Run Flat Indicator. See 36 11 500 INITIALIZING RUN FLAT INDICATOR (RPA)
Version with Tyre Pressure Control: carry out resetting. See 36 11 503 RDC RESETTING