Performing initial operation with test run:
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
- Do not allow any persons to remain in the vehicle or directly on the vehicle
- Keep the vehicle doors closed.
- Maintain a safety distance around the vehicle of 1 m to persons, objects, walls etc.
- Vehicle must be standing horizontally with all wheels on a firm surface
- Do not under any circumstances carry out initial operation on a lifting platform, wheel alignment analyzer or similar!
- Avoid heavy loads
- Check load; if necessary, remove load from the vehicle
- Bring engine up to operating temperatureNOTE: Hydraulic fluid temperature must be between 50°C and 70°C (vehicle at normal operating temperature)
- Connect vehicle to DIS or MoDiC
- Start initial operation in SERVICE FUNCTIONS. Follow instructions in DIS.
- Check and correct fill level with engine stopped