34 21 745 Removing and Installing/Replacing Left Or Right Rear Brake Caliper
Necessary preliminary tasks:
- Remove wheel. See 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL
- Read and comply with General Information. See 34 00 ... General Information
After completing work: Bleed braking system. See 34 00 025 Replacing Fluid in ABS/ASC+T Brake System
Press clutch pedal down to floor and secure with pedal support.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Detach retaining clip (1) in direction of arrow.
Installation:
Retaining clip must be felt and heard to snap into place.
Disconnect brake hose from brake line (2).
Disconnect brake hose from brake line (2).
Installation:
Tightening torque 34 32 1AZ. See 34 32 BRAKE LINES
Detach brake hose from brake caliper (1).
Installation:
Tightening torque 34 32 3AZ. See 34 32 BRAKE LINES
Insert brake hose in bracket and screw onto brake pipe.
Remove brake pads. See 34 21 200 Removing and Installing/Replacing Brake Linings On Both Rear Disc Brakes (Teves Floating Caliper)
Release screws (1).
Remove brake anchor plate in direction of arrow.
Installation:
Tightening torque 34 21 2AZ. See 34 21 REAR BRAKE
Remove brake caliper in direction of arrow.