LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Suspension - Rear) >> Trouble Shooting

Trouble Shooting

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2007 BMW 550i, 2007 BMW 530i, 2007 BMW 525i, 2006 BMW 550i, and 2006 BMW 530i. However, it is still accessible from the selected car via links, so may be relevant.

To trouble shoot most symptoms, see TROUBLE SHOOTING  table.

Whether a spring strut shock absorber has to be replaced can only be ascertained by checking while it is installed with a shock absorber tester or while it is removed with a shock absorber test machine.

TROUBLE SHOOTING

Fault Cause Remedy
Drumming Noise Rubber Mount Of Rear Axle Carrier Faulty Replace Rubber Mount
Drumming Noise Rubber Mount On Final Drive Suspension Faulty Replace Rubber Mount
Drumming Noise Rubber Mount Of Control Arm Faulty Replace Control Arm
Drumming Noise Rubber Mount On Traction Strut Faulty Replace Traction Strut
Drumming Noise Rubber Mounts Of Swinging Arms Faulty Replace Swinging Arm
Grinding Noise Only When Driving In Curves Wheel Bearings Faulty Replace Wheel Bearing
Poor Handling Or Direction Stability Rubber Mount Of Control Arm/Traction Strut Unserviceable Replace Control Arm/Traction Strut
Poor Handling Or Direction Stability Rubber Mount Of Rear Axle Carrier Faulty Replace Rubber Mount
Poor Handling Or Direction Stability Rear Axle Geometry Not OK Perform Chassis alignment check
Excessive Tire Wear Rear Axle Geometry Not OK Perform Chassis alignment check
Rattling Noise Rubber Mount On Rear Axle Carrier Faulty Replace Rubber Mount
Rattling Noise Ball Joint In Wheel Carrier Faulty Replace Ball Joint In Wheel Carrier
Unsteady Taking Of Curves Due To Self-Steering Or Poor Rear End Track Stability Rubber Mount On Rear Axle Carrier Faulty Replace Rubber Mount
Unsteady Taking Of Curves Due To Self-Steering Or Poor Rear End Track Stability Rubber Mount Of Final Drive Suspension Faulty Replace Rubber Mount
Unsteady Taking Of Curves Due To Self-Steering Or Poor Rear End Track Stability Shock Absorber Action Inadequate Replace Shock Absorbers
Vibration Wheels Unbalanced Balance Wheels
Vibration Rims Have Lateral/Radial Runout Replace Rims If Necessary
Vibration Tires Have Radial Runout Match Or Replace Tires