24 14 002 Replacing shaft seal for selector shaft (GA6HP19Z)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 5 361
24 5 362
24 5 364
24 5 366

IMPORTANT: After completion of work, check transmission fluid level.
Use only the approved transmission fluid. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove underbody protection . See 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .

Unfasten nut. Remove cable (1). Installation: Adjusting cable:

Release nut
Adjust cable by means of holder (2)
Distance A = 1.5 mm

Fig 1: Adjust Cable By Means Of Holder (2)

G00497069

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut. Take off holder (1). Tightening torque 24 51 1AZ.

Fig 2: Unfasten Nut And Take Off Holder (1)

G00497070

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 5 361 until it is firmly connected with shaft seal.

Fig 3: Screw In Special Tool 24 5 361 Until It Is Firmly Connected With Shaft Seal

G00497071

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 24 5 362 onto special tool 24 5 361 and tighten down. This pulls the shaft seal out of the transmission housing.

Fig 4: Screw Special Tool 24 5 362 Onto Special Tool 24 5 361 And Tighten Down

G00497072

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal (1). Screw in shaft seal (1) with special tools 24 5 366 and 24 5 364 as far as it will go.

Fig 5: Screw In Shaft Seal (1) With Special Tools 24 5 366 And 24 5 364

G00497073

Courtesy of BMW OF NORTH AMERICA, INC.