24 00 043 Installing replacement transmission (GA6HP26Z)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission fluid at oil drain plug.
Tightening torque, see 24 11 6AZ in AUTOMATIC TRANSMISSION - TIGHTENING TORQUES .
IMPORTANT:
After completion of work, program transmission control unit.
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations.
IMPORTANT:
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Replacement transmission is supplied filled with transmission fluid.
- Before installing replacement transmission, always flush transmission fluid cooler together with lines. See 17 21 500 FLUSHING OIL COOLER WITH LINES (AUTOMATIC TRANSMISSION) .
- After completion of work, check transmission fluid level. See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6HP26Z) .
- Use only the approved transmission fluid. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Replacement transmission is supplied filled with transmission fluid.
Necessary preliminary tasks:
- Remove automatic transmission. See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP26Z) N62TU .
Convert selector lever (1).
Tightening torque. See AUTOMATIC TRANSMISSION - TIGHTENING TORQUES .
Convert holder (2) for cable.
Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Service
- on type plate