17 11 150 Removing and installing/replacing engine oil cooler (N62TU)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Danger of scalding!
Only perform this work after engine has cooled down.

Necessary preliminary tasks:

Remove left wheel arch cover front section.

Release screw.

Installation: Replace sealing rings. Tightening torque, see 17 22 4AZ in 17 22 ENGINE OIL COOLER AND LINES .

Detach oil line (1) from engine oil cooler flange. Catch and dispose of emerging fluid. Unlock and disconnect holder (2). Remove engine oil cooler (3).

Fig 1: Removing Engine Oil Cooler

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: After completing work, check engine oil level and top up if necessary.