LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Suspension - Front) >> Removal & Installation >> Front Axle Carrier >> Installation

Front Axle Carrier: Installation

WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise front axle into place. Tighten both front screws (1) first. See Figure. Tighten rear screws (2). If threads are damaged, they may be repaired with Helicoil thread inserts. Install inserts so they are flush with original thread. Tighten to specification. See TORQUE SPECIFICATIONS .
  2. To complete installation, reverse removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS .
  3. Install lower section of steering spindle to steering gear. See STEERING SPINDLE LOWER SECTION .
  4. On convertible, install tension struts. See TENSION STRUTS .
  5. Install engine underguard and reinforcement plate. Tighten screws to specification. See TORQUE SPECIFICATIONS .
  6. Top up hydraulic fluid reservoir to MAX mark on dipstick. Start engine. Turn steering wheel twice from lock to lock. Turn engine off. Check fluid level and top up, if necessary.
  7. Check pipe connections for leaks.
  8. If necessary, carry out initial operation for Active Front Steering (AFS). See INITIALIZING ACTIVE FRONT STEERING (AFS)  under ADJUSTMENTS.
  9. If necessary, carry out initial operation for Dynamic Drive. See INITIALIZING DYNAMIC DRIVE  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals