11 13 020 Removing And Installing/Replacing Oil Sump Bottom Section (N62/N62TU)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove reinforcement plate.
- Remove oil drain plug and drain engine oil.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws and remove oil sump bottom section (2).
Tightening torque 11 13 2AZ . See ENGINE - TIGHTENING TORQUES (N62TU V8) .
Installation:
Clean sealing surfaces.
Replace seal.
Replace screws.
When replacing oil sump bottom section:
Convert oil level sensor.
Replace sealing ring.