11 12 503 Disassembling And Assembling Cylinder Head (N62/N62TU)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 9 000
11 9 001
11 9 002
11 9 005
11 9 006
11 9 007
11 9 008
11 9 009
11 9 011
11 9 015

Have special tool 11 9 000 ready for removing valve springs.

Secure cylinder head (1) on special tool 11 9 001 .

NOTE: Secure cylinder head from above with screws contained in scope of delivery on special tool 11 9 001 .

Turn special tool 11 9 001 through 180°.

Fig 1: Identifying Cylinder Head On Special Tool (11 9 001)

Courtesy of BMW OF NORTH AMERICA, INC.

Align special tool 11 9 008 in conjunction with special tool 11 9 007 on special tool 11 9 006 to relevant combustion chamber.

Place special tool 11 9 006 on cylinder head.

Fig 2: Identifying Special Tool (11 9 008), (11 9 007) And (11 9 006)

Courtesy of BMW OF NORTH AMERICA, INC.

Slide both special tools 11 9 005 in direction of arrow as far as they will go.

Fig 3: Sliding Special Tool (11 9 005) And (11 9 006)

Courtesy of BMW OF NORTH AMERICA, INC.

Turn lever of special tools 11 9 005 .

Turn special tool 11 9 001 through 180°.

Fig 4: Turning Special Tool (11 9 005) And (11 9 006)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble clamping device with

special tool 11 9 002
special tool 11 9 009
special tool 11 9 011
special tool 11 9 015

Fig 5: Identifying Special Tool (11 9 002), (11 9 009) And (11 9 015)
Courtesy of BMW OF NORTH AMERICA, INC.

Remove all valve springs.

Remove all valve stem seals . See 11 34 560 REPLACING ALL VALVE STEM SEALS (N62) .

Remove all valves . See 11 34 552 REMOVING AND INSTALLING/REPLACING ALL VALVES (N62) .