86 21 ... Installing Sponge Rubber Seal

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removing old sponge rubber seal: Pull off old sponge rubber seal. Remove remaining traces of adhesive with universal cleaner, refer to BMW Operating Fluids.

Sponge rubber seal runs along area marked gray (1).

Fig 1: Identifying Gray Marked Area Of Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Lay sponge rubber seal (1) in middle of hood contact surface (2).

Installation:

Degrease contact surface (2) with benzine and rub down with a dry cloth. Stick on sponge rubber seal (1) according to manufacturer's instructions. Position end face of seal (1) in a straight area.

Fig 2: Identifying Rubber Seal In Middle Of Hood Contact Surface

Courtesy of BMW OF NORTH AMERICA, INC.