52 14 899 Additional work (normal/ electric) with defective drive for longitudinal adjustment

Set seat tilt adjustment to max. up setting.

Release screw (1) on actuator drive (2) of longitudinal seat adjustment.

Fig 1: Actuator Drive And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on servodrive (2) of longitudinal seat adjustment and remove servodrive (2).

Activate the operating switch for the seat position adjustment:

1. No function:
   • Disconnect plug for longitudinal seat adjustment
   • Connect new servodrive and check function
   • If servodrive is running, gear is O.K.
   • Reassemble front seat
2. Actuator drive running:
   • Transmission for longitudinal seat adjustment defective!
   • Continue with

Fig 2: Removing Servodrive

Courtesy of BMW OF NORTH AMERICA, INC.

Disassembly of faulty gear for longitudinal seat adjustment

Disassembly of faulty gear (1) for longitudinal seat adjustment: 

(2) Input shaft

(3) Internal gear

Fig 3: Input Shaft And Internal Gear

Courtesy of BMW OF NORTH AMERICA, INC.

Using a pneumatic saw (1),

cut through drive shaft (2) from rear.

Fig 4: Pneumatic Saw And Drive Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Remove drive shaft (1) from gear (2).

Fig 5: Removing Drive Shaft From Gear

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove gear (2).

Fig 6: Removing Gear And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Over rest of drive shaft (1),

adjust front seat,

release screws on floor panel

and remove front seat.

Fig 7: Removing Gear And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replace seat mechanism on front seat.