51 13 402 Removing and installing/replacing handle strip (on rear lid)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear finisher trim, see 51 13 420 Removing and installing/replacing center rear-end trim section

Release catches (1 and 2) on handle strip (3).

Fig 1: Catches And Handle Strip

G04788433

Courtesy of BMW OF NORTH AMERICA, INC.

Feed handle strip (1) in direction of arrow out of rear finisher (2).

Fig 2: Handle Strip And Rear Finisher

G04788434

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal (1) on handle strip (2) must not be damaged.

Replacement:

If necessary, replace seal (1).

Fig 3: Seal And Handle Strip

G04788435

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, lever out license plate lights (1) at openings (2) in direction of arrow and remove from handle strip (3).

Fig 4: License Plate Lights And Handle Strip

G04788436

Courtesy of BMW OF NORTH AMERICA, INC.