51 47 491 Removing and installing/replacing rear underbody protection
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Illustration created using 3.0d as an example. There may be differences in detail in the case of other models.
Unfasten screws (1) and nuts (2).
Feed out assembly underside protection (3) towards rear and remove.
Installation:
Ensure correct seating.
Centre assembly underside protection (3) and tighten down with screws (1) and nuts (2).