00 00 ... Front and rear brake linings: checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Check brake lining thicknesses with measuring gauge at front and rear, see 34 00 010 CHECKING THICKNESS OF BRAKE PAD
Clean brake shafts
Replace brake linings if they drop below minimum thickness (refer to Technical Data)
Replace brake discs if they drop below minimum thickness (refer to Technical Data) and in event of scoring, heat cracks, lateral runout or thickness difference
Clean wheel centering on alloy wheels and apply a thin coating of grease
Remove front and (if necessary) rear disc brake pads
- Remove and install front disc brake pads, see 34 11 000 REMOVING AND INSTALLING/REPLACING BRAKE LININGS OF BOTH FRONT DISC BRAKES
- Remove and install rear disc brake pads, see 34 21 200 REMOVING AND INSTALLING/REPLACING BOTH REAR DISC BRAKES

Additional tasks when changing rear linings

Remove rear brake discs, see 34 21 320 REMOVING AND INSTALLING/REPLACING BOTH BRAKE DISKS
Check parking brake lining for porosity and wear
Check ease of movement of expander lock

NOTE: Defective brake pads/linings/brake discs must be repaired after consultation with customer and a separate invoice issued