33 21 Output Shaft
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION - OUTPUT SHAFT
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Output shaft to rear axle differential and drive flange | ||||
| Hexagon socket screw | E30, E32, E34 | M10x50 10.9 | Replace screws | 60 Nm |
| Torx screw without ribbed teeth | E30, E31, E32, E34, E36, E38 | M10x50 10.9 (black) | Replace screws | 60 Nm |
| Torx screw with ribbed teeth | E36, E39, E46 | M8x40 (black) | Replace screws | 64 Nm |
| E36, E39, E46, E60, E83, E85 | M8x40 (silver) | Replace screws | 52 Nm | |
| E36 / M54 / Z3 3.0i, E46 | M10x23 10.9 (silver) | Replace screws | 85 Nm | |
| E30, E36, E38, E39, E46, E52, E53, E60, E61, E63, E64, E65, E66, E83, E85, E86 | M10 (silver) | Replace screws | 80 Nm | |
| E36 / Z3 2.8i, E36 / S50 / S52 / S54, E46 / S54, E85 / S54, E86 / S54 | M10x46 10.9 (black) | Replace screws | 100 Nm | |
| E31, E38, E39, E60, E63, E64 | M12x50 10.9 (black) | Replace screws | 135 Nm |