LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (DISC - 525i, 530i & 545i) >> Removal & Installation >> Brake Discs (Front) >> Installation

Brake Discs (Front): Installation

WARNING: This page is about a different car, the 2005 BMW 545i and 2004 BMW 545i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean contact surface of brake disc at wheel hub. Remove traces of corrosion if necessary. Unevenness on contact surface may result in distortion of brake disc.
  2. Install brake disc and tighten bolts to specification. See TORQUE SPECIFICATIONS .
  3. If removed, replace brake linings. See BRAKE LININGS (FRONT) .
  4. Check that brake hose has not been disconnected. If disconnected, make sure it is positively attached when installed. Tighten to specification. See TORQUE SPECIFICATIONS .
  5. Replace caliper and tighten screws to specification. See TORQUE SPECIFICATIONS .
  6. Install wheels and bleed brakes if brake hose was disconnected. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals